open motor
英 [ˈəʊpən ˈməʊtə(r)]
美 [ˈoʊpən ˈmoʊtər]
网络 敞式电动机; 敞开式电动机; 开敞型电动机
双语例句
- I like to study gender relations, Love art, film, photography, music, Internet, clubbing, swimming, diving, open motor boats.
热爱艺术，我喜欢研究性别关系，电影，摄影，音乐，上网，泡吧，游泳，潜水，开摩托艇。 - Open ABS pump/ motor relay output circuit
开放到ABS泵／马达继电器的输出电路 - This is likely to open the door for Hyundai Motor, an alternative bidder, which has been determined to regain control of the construction group.
这可能会为另一个竞购方提供机会：决意夺回现代建设控制权的现代汽车（hyundaimotor）。 - To avoid electrical shock hazards, neither open the cover of the electrical box for the motor nor touch the components mounted inside the electrical box.
为了防止发生触电事故，请不要在打开电源的状态下，打开电气箱盖以及触摸电气箱内的零件。 - First close the plug of a vacuum or pressure meter, if so mounted on the pump, connected to the pump before starting the motor and then open it when the motor move in the normal speed;
如果泵上装有真空表或压力表，要关闭其与泵相连接的旋塞再启动电动机，待转速正常后再打开； - With measures adopted to adjust entrance taper, open of air door, and alignment of the shaft coupling between blower and motor, the main exhaust blower can keep in steady operation.
通过调整入口锥、风门开度、主抽风机与电机之间的联轴器对中等措施，保证了主抽风机稳定运行。 - Design of Open Monitoring and Control Software in Motor Control Center
具有开放性的电动机控制中心监控软件设计 - The Distribution Mode Selection of Full Open or Closed Electrical Motor Operated Valve Driving Equipment
全开全关阀门电动装置配电方式选择 - Frequency Analysis and Its Application in the Diagnosis for the Open Circuit Rotor of Asynchronous Motor
频谱分析及其在异步电动机转子断条诊断方面的应用 - The cause and harm for out of phase running of three phase motor open phase are analyzed, and raise some questions that should be taken note of for normal service and preventing motor open phase running.
对三相电动机发生断相造成缺相运行的原因、危害进行分析，提出进行正常维护，防止电动机断相运行应注意的一些问题。 - Based on short circuit and open circuit electro-magnetic transient analysis of 3-phase stator of inductive motor, the short-circuit feedback current in the medium voltage variable frequency drives ( VFD) are calculated quantitatively.
基于异步电动机三相输入开路及三相输入短路的电磁暂态过程，结合大容量异步电动机的特点，数学上计算了定子短路反馈电流。 - The system allows either open loop or closed loop control of the position and speed of the motor.
该系统可以实现电机位置、速度的开环或闭环控制。 - Open Motion Control System Based on PC and Motor Control Card
基于PC和运动控制卡的开放式运动控制系统 - Compared with the open loop control typically applied in stepper motor control, the combined open-closed loop control scheme is put forward and functions with significant improvement of angle control accuracy.
针对传统的电机步进角开环控制的不足，提出了一种开闭环复合控制方案，提高了控制精度，确保了PCR仪荧光采集精度。 - The existing defect of overload, open phase protection of minitype flameproof motor used in coal mine was analysed and its improved protection scheme was presented.
分析了煤矿井下小型隔爆电动机过载、断相保护存在的缺陷，提出了改进的保护方案。 - In view of the problems existing in open loop system of CNC machine tools with stepper motor as driving motor, such as lower servo precision, without compensation for step-losing of stepper motor and so on, this paper presents a new technique called quasi-close loop control.
针对以步进电机作为驱动电机的数控机床开环系统存在的一些问题，诸如伺服精度低、失步误差不能补偿等，文章提出了一种新的控制技术&准闭环控制。 - The items that will be experimented in the motor trial include: resistance trial, rotor open voltage trial ( round motor), unload trial, load trial, temperature promotion trial, and MS curve trial.
进行电机测试试验的试验项目包括：电阻试验、转子开路电压试验（绕线电机）、空载试验、堵转试验、负载试验、温升试验、MS曲线试验等项目。 - Monitoring sub-station on the contact button to switch to enter the extension in the SCM at the same time, direct box to connect to the emergency monitoring by a dedicated cable connected to the electric power monitoring counters, open to stop the achievement of motor control.
分站上的监控按钮开关接点在进入分机内的单片机的同时，直接连接到应急监控箱内，由专用电缆连接到电机电源监控柜，实现电机开停控制。 - Although it is suggested that continuous tracking algorithm use, but this method only applies to open loop control, easily to cause stepper motor out of step.
虽然有研究者提出采用连续跟踪算法，但该算法只适用于开环控制，容易造成步进电机失步。 - The driving circuit of stepping-motor with the function of over-load protection and short-circuit protection is established; the accurate control characteristic of open degree of EEV is realized by the way of driving stepping motor directly and four-phase-eight-pat controlling pattern.
设计了具有过载保护与短路保护的步进电机驱动电路，采用PLC直接驱动步进电机驱动方式与四相八拍控制方式，实现对电子膨胀阀开度的精确控制。 - This text will introduce the rapid modeling system for astigmatism veins of motor lamps in details. It is based on the platform of large 3D CAD software UG NX. Meanwhile it makes use of secondary exploit language Open GRIP, which is quite easy and interactive.
本文将详细介绍基于大型三维CAD软件UGNX软件平台，利用简单易学、交互性强的二次开发语言OpenGrip，开发出的实用性强、操作简单、稳定性好的汽车车灯配光纹快速建模系统。